Brick vs block drilling: Drill Bit Size Tips for a Secure towel bar Install

Choosing the right drill bit size for brick vs block drilling is the fastest way to get a secure install for a towel bar in cinder block. Most anchor problems come from one thing: the hole does not match the anchor body. Use the steps below to get a snug fit, avoid spinning anchors, and prevent wall damage.

How to pick the correct bit size

• Identify the wall: drywall behaves differently than plaster, and masonry requires a carbide-tipped bit.
• Start with the anchor body: the anchor sets the hole size; the screw choice mainly affects capacity.
• Use the manufacturer size when available: packaging often lists a fractional-inch or numbered drill size designed for that exact anchor.
• If no size is listed, match the bit to the anchor shank diameter (not the flange). The anchor should press in firmly without deforming the wall.
• Control depth: mark the bit with tape so the anchor seats fully and sits flush.

Common mistakes and quick fixes

• Oversized hole: step up to a larger anchor, or switch to a toggle-style anchor for hollow walls.
• Undersized hole: re-drill slightly larger instead of hammering hard, which can crack plaster or chip tile.
• Anchor spins: the hole is usually too large or the wall is too soft; choose an anchor that locks behind the wall or expands more aggressively.
• Crumbled masonry: drill slower, clean dust, and consider a sleeve anchor or concrete screw designed for your base material.

Before you hang the load

• Flush check: the anchor is seated flat to the surface without bulging the drywall paper.
• Set check: the screw tightens with steady resistance and does not free-spin.
• Gentle pull test: tug down and out by hand to confirm the anchor is engaged.

For a towel bar, a tight, straight hole is more important than speed. When you are between bit sizes, test on a scrap first and choose the smallest bit that allows proper seating. That small step prevents most stripped holes and gives you a cleaner, stronger result.

Pro tip: keep a small index card in your drill case with notes on which anchor brands you use most and the bit that fit best. Even small brand-to-brand differences add up, and your future installs will go faster with fewer surprises.

In Summary: The most important thing about Brick vs block drilling: Drill Bit Size Tips for a Secure towel bar Install is getting the basics right. Apply the tips above and you will avoid the most common pitfalls.

Related guides: Wall Anchor And Drill Bit Selection Guidelines Us , Stud Plus Drywall Fastener Bit Bathroom Mirror 1 2 Inch Drywall 86 , Self Drilling Drywall Anchors Pilot Hole Size Bathroom Mirror 1 2 Inch Drywall 5 , Plastic Expansion Anchors Drill Bit Size Curtain Rod Brick 30

Related guides: Plaster Lath Anchor Bit Size Curtain Rod Double Layer Drywall 37 , Hollow Wall Anchors Drill Bit Size Coat Rack Cinder Block 77 , Concrete Screws Bit Size Cabinet Tile Over Cement Board 72 , Index

Share this guide:

Frequently Asked Questions about Brick vs block drilling: Drill Bit Size Tips for a Secure towel bar Install