KitchenAid Error Code 6-4: Float Switch and Water Level Fix
Updated: February 2026
The KitchenAid error code 6-4 indicates your dishwasher is having trouble regulating water levels. This could mean too much water, too little water, or a malfunctioning float switch.
Understanding Error 6-4
The float switch monitors water level and prevents overfilling. When it gets stuck, the control board receives incorrect signals, triggering the 6-4 error. Alternatively, the water inlet valve might be malfunctioning, causing improper fill levels.
Complete Repair Process
- Step 1: Open the dishwasher door and remove the lower dish rack to access the interior base.
- Step 2: Locate the float assembly—a small plastic dome in the front corner of the tub base. Lift it up and down to test movement.
- Step 3: If the float is stuck, remove any debris trapped underneath. Clean the float housing thoroughly with warm water.
- Step 4: Check under the float for excessive foam from too much detergent. Wipe clean and reduce detergent in future loads.
- Step 5: Inspect the water inlet valve screen for clogs. Turn off the water supply, disconnect the inlet hose, and clean the screen with a soft brush.
- Step 6: Test the water inlet valve with a multimeter. It should show 500-1500 ohms of resistance.
- Step 7: Verify proper water pressure to the dishwasher (20-120 psi). Low pressure can cause fill issues.
After repairs, run a test cycle and watch the fill process. The water should stop just below the heating element. If the 6-4 error continues, the pressure switch or control board may need professional diagnosis.
Takeaway: Now that you understand KitchenAid Error Code 6-4: Float Switch and Water Level Fix, put this knowledge into practice. Real-world experience combined with this guide will make you an expert.
Related guides: Error Code 8 4 , Dishwasher Error Ftd , Dishwasher Error I10 , Dishwasher Error I20
Related guides: Dishwasher Error I30 , Dishwasher Error C1 , Dishwasher Error C2 , Dishwasher Error C3
Related guides: Dishwasher Error C4 , Dishwasher Error C6 , Dishwasher Error C7 , Dishwasher Error C8
Frequently Asked Questions about KitchenAid Error Code 6-4: Float Switch and Water Level Fix
Is KitchenAid Error Code 6-4: Float Switch and Water Level Fix suitable for beginners?
Yes, absolutely. Our guide to KitchenAid Error Code 6-4: Float Switch and Water Level Fix explains all basics clearly.
How much does KitchenAid Error Code 6-4: Float Switch and Water Level Fix cost?
Costs vary depending on the provider. A comparison is always worth it.
Where can I find more information?
Right here in our expert area for Dishwasher Error Codes & Troubleshooting.